Drillnado - $50 (richmond / seacliff)

NEW The drill press station has always been one of the messiest corners of any workshop because traditional dust collectors can't get adequate suction close enough to the working end of the bit.
By fully surrounding your drill press chuck and bit the Drillnado is able to capture chips and dust right at the source.
The Drillnado can connect to any existing dust collection system or shop vac and is able to attach to drill press quills up to 2.
6" in diameter while the Drillnado XL attaches to drill presses with quills 2.
95" or less in diameter.
For both units, the expandable housing can accommodate drill bits up to 1-5/8" in diameter out of the box, but they can be cut to size to accommodate bits up to 3-1/8" diameter.
Expandable housing stretches to just above the cutting edge of the drill bit, resulting in maximum dust collection efficiency Works with drill bits up to 1-5/8" in diameter or cut the housing to work with bits up to 3-1/8" diameter Drillnado (item 115-120) Works on most 12" and smaller floor model and bench top drill presses with quill diameter of less than 2.
6” Bushings and shims included for use on drill presses with 2.
6”, 2.
54”, 2.
16”, 2.
05”, and 1.
57” quill diameters Drillnado XL (item 115-121) works on 13" and larger drill presses with quill diameters 2.
95" and smaller Connects to a dust collection system or shop vac with a 2-1/4" or 2-1/2" fitting Housing quick-disconnects for fast bit changes Uses in your shop: Hang up the broom and dust pan you keep next to the drill press for good Sucks up almost all dust and debris from your drill press table